43 lines
1.4 KiB
Markdown
43 lines
1.4 KiB
Markdown
# Bench-Data
|
|
|
|
> [!WARNING]
|
|
> This software was developped for linux, Windows compatibility is not guaranted
|
|
|
|
This repository contains both the arduino firmware and python connector to feed RPM and Lambda to a dynalab-core software
|
|
## Requirements
|
|
To use the software you will need to install `uv` to manage the python project [docs.astral.sh](https://docs.astral.sh/uv/getting-started/installation/)
|
|
## Setup
|
|
First, clone the repository:
|
|
```bash
|
|
git clone https://git.h3cx.dev/Exergie/Bench-Data-Processing.git
|
|
```
|
|
After that, you will need to go to the connector repository and sync the project:
|
|
```bash
|
|
cd Bench-data/bench-data-connector
|
|
uv sync
|
|
```
|
|
Then to run the program you will just have to run the following command into your terminal:
|
|
```bash
|
|
uv run bench-data-connector
|
|
```
|
|
## Usage
|
|
To use the program you will have to plug in the arduino into a port of your pc. Then when the program is executed you will have to select the port where the arduino is pluged in.
|
|
```
|
|
27: /dev/ttyS5 n/a
|
|
28: /dev/ttyS3 n/a
|
|
29: /dev/ttyS2 n/a
|
|
30: /dev/ttyS1 n/a
|
|
31: /dev/ttyS0 n/a
|
|
32: /dev/ttyUSB0 USB Serial
|
|
Choose a port to connect: 32
|
|
```
|
|
Once the port is selected the arduino is going to operate a sync with the pc during 30 seconds, so no data will appear in the first 30 seconds.
|
|
```
|
|
Waiting 5 seconds before synchronization...
|
|
```
|
|
Once the sync is done the data should start to appear:
|
|
```
|
|
sync ok
|
|
Offset:2626280123208.57
|
|
Scale:1.006884777346364
|
|
``` |