# Current Development Setup

This file holds the current `CM7` development setup and implementation specificities. The target architecture is documented in [`ARCHITECTURE.md`](./ARCHITECTURE.md).

## Platform

Current bench development targets the STM32H747 on the Arduino Giga platform.

The present `CM7` code uses:

- STM32 HAL
- FreeRTOS
- CMSIS-RTOS v2
- `TIM2` as the main engine-control timer

The current pin mapping is provisional:

- `TIM2_CH1` / `PA0`: crank input capture
- `TIM2_CH2` / `PA1`: cam input capture
- `TIM2_CH3` / `PA2`: scheduled spark output compare

## Implementation Specificities

### Spark Charge Step

The current spark path forces a charge transition before scheduling the release transition. This is temporary and belongs to the development setup, not the target architecture.

The final design should handle dwell time explicitly:

- compute when charging must begin
- compute when spark must release
- schedule both as normal output-compare transitions

### Injection Placeholder

Injection scheduling is not complete. `tasks/crank.c` contains an early placeholder based on `INJECTION_PHASE`, but there is no finished actuator path yet.

### Sync Filtering

The broad sync model is implemented, but thresholds and recovery behavior still need hardware validation. Current behavior includes:

- `SYNC_NOT_OK`, `SYNC_PENDING`, and `SYNC_OK`
- limited cam miss tolerance through `MAX_CAM_MISS`
- crank interval filtering while synchronized
- sync loss when cam timing is inconsistent with the expected crank state

### Timer and Pin Routing

`TIM2` and the current Arduino Giga pins are useful for bench work. They should not be treated as final ECU hardware routing.